Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM B16/B16M-05

Standard Specification for Free-Cutting Brass Rod, Bar and Shapes for Use in Screw Machines

Standard Specification for Free-Cutting Brass Rod, Bar and Shapes for Use in Screw Machines B0016_B0016M-05 ASTM|B0016_B0016M-05|en-US Standard Specification for Free-Cutting Brass Rod, Bar and Shapes for Use in Screw Machines Standard new BOS Vol. 02.01 Committee B05
$ 75.00 In stock

Abstract

This specification establishes the requirements for free-cutting brass rod, bar, wire, and shapes of any specified cross-section produced from Copper Alloy UNS No. C36000 suitable for high-speed screw machining applications and moderate thread rolling. The chemical composition, temper, tensile, Rockwell hardness, and shape requirements are detailed.

Scope

1.1 This specification establishes the requirements for free-cutting brass rod, bar, wire, and shapes of any specified cross section produced from Copper Alloy UNS No. C36000 suitable for high-speed screw machining applications and moderate thread rolling.

1.2 UnitsValues stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 02.01
Developed by Subcommittee: B05.02
Pages: 5
DOI: 10.1520/B0016_B0016M-05
ICS Code: 77.150.30