ASTM B161-05(2014)

    Standard Specification for Nickel Seamless Pipe and Tube


      Format Pages Price  
    PDF 3 $54.00   ADD TO CART


    1. Scope

    1.1 This specification2 covers nickel (UNS N02200)3 and low-carbon nickel (UNS N02201)3 in the form of cold-worked seamless pipe and tube in the conditions shown in Table 1 and Table X1.1.

    1.1.1 Hot-worked material is available. Properties are to be agreed upon between the manufacturer and purchaser.

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B829 Specification for General Requirements for Nickel and Nickel Alloys Seamless Pipe and Tube


    ICS Code

    ICS Number Code 77.150.40 (Nickel and chromium products)

    UNSPSC Code

    UNSPSC Code


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0161-05R14

    Citation Format

    ASTM B161-05(2014), Standard Specification for Nickel Seamless Pipe and Tube, ASTM International, West Conshohocken, PA, 2014, www.astm.org

    Back to Top