ASTM B154-12

    Standard Test Method for Mercurous Nitrate Test for Copper Alloys


      Format Pages Price  
    PDF 4 $54.00   ADD TO CART


    1. Scope

    1.1 This test method describes the technique for conducting the mercurous nitrate test for residual stresses in wrought copper alloy mill products.

    Note 1For any particular copper alloy, reference should be made to the material specification.
    Note 2Test Method B858 may be considered as a possible alternative test method which does not involve the use of mercury.
    Note 3This test method is considered historically reliable for determining the potential state of residual stress in copper alloys, but not promoted for use due to the hazards relating to mercury use and environmentally appropriate disposal.

    1.2 Units—The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determines the applicability of regulatory limitations prior to use. For specific precautionary and hazard statements see Sections 1, 6, and 7. (Warning—Mercury has been designated by EPA and many state agencies as a hazardous material that can cause central nervous system, kidney and liver damage. Mercury, or its vapor, may be hazardous to health and corrosive to materials. Caution should be taken when handling mercury and mercury containing products. See the applicable product Material Safety Data Sheet (MSDS) for details and EPA's website – http://www.epa.gov/mercury/faq.htm – for additional information. Users should be aware that selling mercury and/or mercury containing products into your state may be prohibited by state law.)


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B846 Terminology for Copper and Copper Alloys

    B858 Test Method for Ammonia Vapor Test for Determining Susceptibility to Stress Corrosion Cracking in Copper Alloys

    D1193 Specification for Reagent Water


    ICS Code

    ICS Number Code 77.120.30 (Copper and copper alloys)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0154-12

    Citation Format

    ASTM B154-12, Standard Test Method for Mercurous Nitrate Test for Copper Alloys, ASTM International, West Conshohocken, PA, 2012, www.astm.org

    Back to Top