SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|9||$62.00||  ADD TO CART|
1.1 This specification establishes the requirements for electrolytic copper cathode; electrorefined and electrowon.
1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
Note 1—Cathode produced to this specification corresponds to the designation “Cath” as defined in Classification B224 and may be used to produce all other coppers listed in Classification B224 that are normally produced from “Cath” copper.
Note 2—Grade 1 cathode conforms to the chemical compositional requirements of Copper UNS No. C11040, except for oxygen, and is suitable for the manufacture of wire rod as designated in Specification B49.
1.3 The following hazard caveat applies to the test methods described in Annex A2 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B49 Specification for Copper Rod for Electrical Purposes
B193 Test Method for Resistivity of Electrical Conductor Materials
B224 Classification of Coppers
B846 Terminology for Copper and Copper Alloys
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E50 Practices for Apparatus, Reagents, and Safety Considerations for Chemical Analysis of Metals, Ores, and Related Materials
E53 Test Method for Determination of Copper in Unalloyed Copper by Gravimetry
ICS Number Code 77.150.30 (Copper products)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B115-10, Standard Specification for Electrolytic Copper Cathode, ASTM International, West Conshohocken, PA, 2010, www.astm.orgBack to Top