ASTM B100 - 13 Standard Specification for Wrought Copper-Alloy Bearing and Expansion Plates and Sheets for Bridge and Other Structural Use

ASTM B100-13

Standard Specification for Wrought Copper-Alloy Bearing and Expansion Plates and Sheets for Bridge and Other Structural Use

SUPERSEDED (click for Active standard)

	Format	Pages	Price
	PDF	5	$62.00	ADD TO CART

Reprints and Permissions

Permissions to reprint documents can be acquired through
Copyright Clearance Center Visit Copyright Clearance Center

Reprints and Permissions

Permissions to reprint documents can be acquired through
Copyright Clearance Center

Visit Copyright Clearance Center

Reprints and Permissions

Permissions to reprint documents can be acquired through
Copyright Clearance Center

Visit Copyright Clearance Center

Active (view current version of standard)

Other Historical Standards

ASTM License Agreement

More B05.01 Standards Related Products

1. Scope

1.1 This specification establishes the requirements for wrought copper-alloy bearing plate and bearing sheets for application in bridges and other structures. Specifically, the plates and sheets are to be used for fixed or expansion bearings where the motion is slow and intermittent with pressures not exceeding 3 ksi (20 MPa).

1.2 Units—Values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

B248 Specification for General Requirements for Wrought Copper and Copper-Alloy Plate, Sheet, Strip, and Rolled Bar

B846 Terminology for Copper and Copper Alloys

E8/E8M Test Methods for Tension Testing of Metallic Materials

E9 Test Methods of Compression Testing of Metallic Materials at Room Temperature

E10 Test Method for Brinell Hardness of Metallic Materials

E18 Test Methods for Rockwell Hardness of Metallic Materials

E54 Test Methods for Chemical Analysis of Special Brasses and Bronzes

E62 Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods)

E255 Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition

E478 Test Methods for Chemical Analysis of Copper Alloys

ICS Code

ICS Number Code 77.150.30 (Copper products)

UNSPSC Code

UNSPSC Code 30102209(Copper plate)

Referencing This Standard

Link Here

Link to Active (This link will always route to the current Active version of the standard.)

DOI: 10.1520/B0100-13

Citation Format

ASTM B100-13, Standard Specification for Wrought Copper-Alloy Bearing and Expansion Plates and Sheets for Bridge and Other Structural Use, ASTM International, West Conshohocken, PA, 2013, www.astm.org