ASTM A985-98a

    Standard Specification for Steel Investment Castings General Requirements, for Pressure-Containing Parts

      Format Pages Price  
    PDF 14 $62.40   ADD TO CART

    1. Scope

    1.1 This specification covers a group of common requirements, which are mandatory for steel castings produced by the investment casting process for pressure-containing parts under each of the following ASTM Specifications:

    Title of SpecificationASTM Designation
    Steel Castings, Carbon, Suitable for Fusion Welding A 216/A 216M
    for High-Temperature Service
    Steel Castings, Martensitic Stainless and Alloy, for A 217/A 217M
    Pressure-Containing Parts Suitable for High-
    Temperature Service
    Castings, Austenitic, Austenitic-Ferritic (Duplex), A 351/A 351M
    for Pressure-Containing Parts
    Steel Castings, Ferritic and Martensitic, for Pressure- A 352/A 352M
    Containing Parts Suitable for Low-Temperature
    Steel Castings, Alloy, Specially Heat-Treated, for A 389/A 389M
    Pressure-Containing Parts, Suitable for High-
    Temperature Service
    Steel Castings Suitable for Pressure Service A 487/A 487M

    1.2 This specification also covers a group of supplementary requirements, which may be applied to the above specifications as indicated therein. These requirements are provided for use when additional testing or inspection is desired and apply only when specified individually by the purchaser in the order.

    1.3 When investment casting are ordered, the requirements of this specification shall take precedence over the individual material specification requirements.

    1.4 The values stated in either inch-pound or SI units are to be regarded separately as the standard. Within the text, the SI units are shown in parentheses. The values in each system are not exact equivalent; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification. Inch-pound units are applicable for material ordered to Specification A 985 and SI units for material ordered to Specification A 985M.

    1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    ICS Code

    ICS Number Code 49.025.10 (Steels)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/A0985-98A

    Citation Format

    ASTM A985-98a, Standard Specification for Steel Investment Castings General Requirements, for Pressure-Containing Parts, ASTM International, West Conshohocken, PA, 2001,

    Back to Top