ASTM A983/A983M-06(2011)

    Standard Specification for Continuous Grain Flow Forged Carbon and Alloy Steel Crankshafts for Medium Speed Diesel Engines

      Format Pages Price  
    PDF 5 $55.20   ADD TO CART

    1. Scope

    1.1 This specification covers continuous grain flow forged carbon and alloy steel crankshafts for medium speed diesel and natural gas engines.

    1.2 The steel used in the manufacture of the forgings is required to be vacuum degassed.

    1.3 The choice of steel composition grade for a given strength class is normally made by the forging supplier, unless otherwise specified by the purchaser.

    1.4 Provision is made for treatment of designated surfaces of the crankshaft to provide enhanced fatigue strength, or wear resistance, or both.

    1.5 Except as specifically required in this specification, all provisions of Specification A788/A788M apply.

    1.6 Unless the order specifies the applicable M specification designation, the material shall be furnished to the inch-pound units.

    1.7 The values stated in either inch-pound units or SI (metric) units are to be regarded separately as standard. Within the text and tables the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A370 Test Methods and Definitions for Mechanical Testing of Steel Products

    A503/A503M Specification for Ultrasonic Examination of Forged Crankshafts

    A788/A788M Specification for Steel Forgings, General Requirements

    A966/A966M Practice for Magnetic Particle Examination of Steel Forgings Using Alternating Current

    A986/A986M Specification for Magnetic Particle Examination of Continuous Grain Flow Crankshaft Forgings

    E45 Test Methods for Determining the Inclusion Content of Steel

    E112 Test Methods for Determining Average Grain Size

    E340 Practice for Macroetching Metals and Alloys

    Other Standards

    AWS D1.1

    JIS G 0555 Microscopic Testing Method for the Non-Metallic Inclusions in Steel Available from Japanese Standards Association (JSA), Mita MT Bldg., 3-13-12 Mita, Minato-ku, Tokyo 108-0073, Japan,

    ICS Code

    ICS Number Code 27.020 (Internal combustion engines)

    UNSPSC Code

    UNSPSC Code 31132100(Steel forgings)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/A0983_A0983M-06R11

    Citation Format

    ASTM A983 / A983M-06(2011), Standard Specification for Continuous Grain Flow Forged Carbon and Alloy Steel Crankshafts for Medium Speed Diesel Engines, ASTM International, West Conshohocken, PA, 2011,

    Back to Top