ASTM A966/A966M-96

    Standard Test Method for Magnetic Particle Examination of Steel Forgings Using Alternating Current

      Format Pages Price  
    PDF 6 $55.20   ADD TO CART

    1. Scope

    1.1 This test method covers a procedure for the magnetic particle examination of steel forgings using alternating current as the power source. The procedure will produce consistent results upon which acceptance standards can be based. This test method does not contain acceptance limits or recommended quality levels.

    1.2 Only alternating 50-60 cycle current shall be used as the electric power source for any of the magnetizing methods. The ability to detect subsurface discontinuities is very limited when using an alternating power source , and therefore the test surfaces should be in the final thermally treated and finish machined condition.

    1.3 When subsurface indications are sought in forgings, then dc magnetization in accordance with Test Method A 275/A 275M should be used.

    1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text , the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independent of the other. Combining values from the two systems may result in nonconformance with the specification. Unless the order specifies the applicable "M" specification designation [SI units], the inch-pound units shall be used.

    1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A275/A275M Practice for Magnetic Particle Examination of Steel Forgings

    A508/A508M Specification for Quenched and Tempered Vacuum-Treated Carbon and Alloy Steel Forgings for Pressure Vessels

    A788/A788M Specification for Steel Forgings, General Requirements

    A963/A963M Specification for Deep Drawing Steel (DDS), Sheet, Carbon, Cold-Rolled

    Other Document

    Practice No. SNT-TC-1A, Supplement B--Magnetic Particle Method Available from American Society for Nondestructive Testing (ASNT), P.O. Box 28518, 1711 Arlingate Ln., Columbus, OH 43228-0518,

    UNSPSC Code

    UNSPSC Code 31132100(Steel forgings)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/A0966_A0966M-96

    Citation Format

    ASTM A966 / A966M-96, Standard Test Method for Magnetic Particle Examination of Steel Forgings Using Alternating Current, ASTM International, West Conshohocken, PA, 1996,

    Back to Top