SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|3||$48.00||  ADD TO CART|
1.1 This specification covers hot-wrought, special quality microalloyed carbon steel bars intended for use in applications where as-rolled mechanical properties are desired. A typical end use is hydraulic cylinder shafts.
1.2 The bars shall be furnished to chemical composition and mechanical properties as provided herein. Chemical composition is based on standard carbon steel grades modified to include microalloying elements such as columbium (niobium), vanadium, or molybdenum. Four strength classes are available, designated 60, 75, 80, and 100, corresponding to the minimum yield strength in ksi.
1.3 Sections and sizes of bar steels available are covered in Specification A 29/A 29M.
1.4 Supplementary Requirements S1 to S5 are provided for use when additional controls or requirements are desired. These shall apply only when specified on the purchase order.
1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text and tables, SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.6 Unless the order specifies the applicable "M" specification designation, the material shall be furnished to the inch-pound units.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A29/A29M Specification for General Requirements for Steel Bars, Carbon and Alloy, Hot-Wrought
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
A576 Specification for Steel Bars, Carbon, Hot-Wrought, Special Quality
E45 Test Methods for Determining the Inclusion Content of Steel
ICS Number Code 77.140.20 (Steels of high quality)
UNSPSC Code 30263700(Steel alloy bars)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM A920 / A920M-97, Standard Specification for Steel Bars, Microalloy, Hot-Wrought, Special Quality, Mechanical Properties, ASTM International, West Conshohocken, PA, 2002, www.astm.orgBack to Top