ASTM A835/A835M-84(2005)

    Standard Specification for Sizes of Ferroalloys and Alloy Additives

      Format Pages Price  
    PDF 2 $49.20   ADD TO CART

    1. Scope

    1.1 This specification covers standard nominal sizes and size tolerances of screened ferroalloy and alloy additive products. This specification provides a range of sizes as referenced in all ASTM specifications for ferroalloys and alloy additives.

    1.2 The sizes and tolerances allow for varying degrees of friability upon receipt of material since some attrition may be expected in transit, storage, and handling.

    1.3 Specifications of sieve sizes used to define tolerances are listed in Specification E 11. Representative procedures for evaluation of each lot are described in Methods A 610. Refer to for applicable sieve designations (see ).

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A610 Test Methods for Sampling and Testing Ferroalloys for Determination of Size

    E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves

    ICS Code

    ICS Number Code 77.100 (Ferroalloys)

    UNSPSC Code

    UNSPSC Code

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/A0835_A0835M-84R05

    Citation Format

    ASTM A835 / A835M-84(2005), Standard Specification for Sizes of Ferroalloys and Alloy Additives, ASTM International, West Conshohocken, PA, 2005,

    Back to Top