SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|4||$48.00||  ADD TO CART|
1.1 This specification covers structural quality carbon steel plates furnished to chemical composition requirements.
1.2 The plates are available in several standard steel grades and non-standard grades.
1.3 The plates are usually furnished in the as-rolled (hot-rolled) condition.
1.4 Supplementary requirements are provided for additional requirements that may be specified on the order.
1.5 When the steel is to be welded, it is presupposed that a welding procedure suitable for the grade of steel and intended use or service will be utilized. See Appendix X3 of Specification A6/A6M for information on weldability.
1.6 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A6/A6M Specification for General Requirements for Rolled Structural Steel Bars, Plates, Shapes, and Sheet Piling
ICS Number Code 77.140.50 (Flat steel products and semi-products)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM A830 / A830M-11, Standard Specification for Plates, Carbon Steel, Structural Quality, Furnished to Chemical Composition Requirements, ASTM International, West Conshohocken, PA, 2011, www.astm.orgBack to Top