ASTM A772/A772M-00(2005)

    Standard Test Method for ac Magnetic Permeability of Materials Using Sinusoidal Current

      Format Pages Price  
    PDF 4 $49.20   ADD TO CART

    1. Scope

    1.1 This test method provides a means for determination of the impedance permeability (µz) of ferromagnetic materials under the condition of sinusoidal current (sinusoidal H) excitation. Test specimens in the form of laminated toroidal cores, tape-wound toroidal cores, and link-type laminated cores having uniform cross sections and closed flux paths (no air gaps) are used. The method is intended as a means for determining the magnetic performance of ferromagnetic strip having a thickness less than or equal to 0.025 in. [0.635 mm].

    1.2 This test method shall be used in conjunction with those applicable paragraphs in Practice A34/A34M.

    1.3 The values and equations stated in customary (cgs-emu and inch-pound) or SI units are to be regarded separately as standard. Within this standard, SI units are shown in brackets except for the sections concerning calculations where there are separate sections for the respective unit systems. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this standard.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A34/A34M Practice for Sampling and Procurement Testing of Magnetic Materials

    A340 Terminology of Symbols and Definitions Relating to Magnetic Testing

    ICS Code

    ICS Number Code 29.030 (Magnetic materials)

    UNSPSC Code

    UNSPSC Code 31380000(Magnets and magnetic materials)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/A0772_A0772M-00R05

    Citation Format

    ASTM A772 / A772M-00(2005), Standard Test Method for ac Magnetic Permeability of Materials Using Sinusoidal Current, ASTM International, West Conshohocken, PA, 2005,

    Back to Top