ASTM A663/A663M-89(2000)

    Standard Specification for Steel Bars, Carbon, Merchant Quality, Mechanical Properties

      Format Pages Price  
    PDF 3 $49.20   ADD TO CART

    Active (view current version of standard)

    Other Historical Standards

    Work Item(s) - proposed revisions of this standard

    ASTM License Agreement

    More A01.15 Standards Related Products

    1. Scope

    1.1 This specification covers hot-wrought merchant quality carbon steel bars and bar size shapes produced to mechanical property requirements and intended for noncritical constructional applications (see 3.2).

    1.2 Merchant quality hot-wrought steel bar is available in the following ranges of size and section:

    1.2.1 Rounds, squares, and hexagons with diameters or distance across flats under 3 in. [75 mm].

    1.2.2 Bar size shapes with maximum dimensions under 3 in. [75 mm].

    1.2.3 Other bar sections with weight per foot under 40.84 lb/ft [60.78 kg/m].

    1.2.4 Flats 6 in. [152 mm] or under in width, over 0.203 in. [over 5 mm in thickness up to 150 mm in width] in thickness, and under 40.84 lb/ft or 12 in2[77.4 cm2 ] in cross-sectional area.

    1.2.5 Flats over 6 in. to 8 in., inclusive in width, 0.230 in. and over [over 6 mm in thickness and over 50 mm through 200 mm in width] in thickness and under 40.84 lb/ft [60.78 kg/m] or 12 in.2 [77.4 cm2] in cross-sectional area.

    1.2.6 Hot-wrought merchant quality carbon steel bars subject to mechanical property requirements are hot wrought in straight lengths only.

    1.3 Some applications may require one or more of the available designations shown under supplementary requirements.

    Note 1--Special quality hot-wrought carbon steel bars subject to mechanical property requirements are covered in Specification A675/A675M.

    1.4 The values stated in either inch-pound units or SI units are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The values stated in each system are not equivalents, therefore each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A29/A29M Specification for Steel Bars, Carbon and Alloy, Hot-Wrought, General Requirements for

    A370 Test Methods and Definitions for Mechanical Testing of Steel Products

    A675/A675M Specification for Steel Bars, Carbon, Hot-Wrought, Special Quality, Mechanical Properties

    E290 Test Methods for Bend Testing of Material for Ductility

    ICS Code

    ICS Number Code 77.140.60 (Steel bars and rods)

    UNSPSC Code

    UNSPSC Code 30263600(Carbon steel bars)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/A0663_A0663M-89R00

    Citation Format

    ASTM A663 / A663M-89(2000), Standard Specification for Steel Bars, Carbon, Merchant Quality, Mechanical Properties, ASTM International, West Conshohocken, PA, 2000,

    Back to Top