SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|4||$49.20||  ADD TO CART|
1.1 This specification covers grades of stainless steel tubing in sizes under ½ down to 0.050 in. (12.7 to 1.27 mm) in outside diameter and wall thicknesses less than 0.065 in. down to 0.005 in. (1.65 to 0.13 mm) for general corrosion-resisting and low- or high-temperature service, as designated in Table 1.
Note 1--The grades of austenitic stainless steel tubing furnished in accordance with this specification have been found suitable for low-temperature service down to -325oF (-200oC) where Charpy notched-bar impact values of 15 ft[dot]lbf (20 J), minimum, are required and these grades need not be impact tested.
1.2 Optional supplementary requirements are provided and, when desired, shall be so stated in the order.
1.3 The values stated in inch-pound units are to be regarded as the standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A262 Practices for Detecting Susceptibility to Intergranular Attack in Austenitic Stainless Steels
A380 Practice for Cleaning, Descaling, and Passivation of Stainless Steel Parts, Equipment, and Systems
E165 Practice for Liquid Penetrant Examination for General Industry
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
SAE StandardSAE J 1086 Practice for Numbering Metals and Alloys (UNS) Available from SAE International (SAE), 400 Commonwealth Dr., Warrendale, PA 15096-0001, http://www.sae.org.
ICS Number Code 23.040.10 (Iron and steel pipes); 23.040.40 (Metal fittings)
UNSPSC Code 40181900(Welded stainless steel tubes); 31351209(Stainless steel welded or brazed tube assemblies)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM A632-01, Standard Specification for Seamless and Welded Austenitic Stainless Steel Tubing (Small-Diameter) for General Service, ASTM International, West Conshohocken, PA, 2001, www.astm.orgBack to Top