ASTM A623M-10

    Standard Specification for Tin Mill Products, General Requirements [Metric]

      Format Pages Price  
    PDF 25 $80.40   ADD TO CART

    1. Scope

    1.1 This specification covers a group of common requirements which, unless otherwise specified in the purchase order or in an individual specification, shall apply to tin mill products.

    1.2 In case of conflict in requirements, the requirements of the purchase order, the individual material specification,and this general specification shall prevail in the sequence named.

    1.3 The following safety hazards caveat covers Annex A1 through Annex A8 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    Note 1—A complete inch-pound companion to Specification A623M has been developedA623; therefore, no inch-pound equivalents are presented.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A370 Test Methods and Definitions for Mechanical Testing of Steel Products

    A700 Guide for Packaging, Marking, and Loading Methods for Steel Products for Shipment

    A987 Practice for Measuring Shape Characteristics of Tin Mill Products

    E18 Test Methods for Rockwell Hardness of Metallic Materials

    E112 Test Methods for Determining Average Grain Size

    ICS Code

    ICS Number Code 77.140.50 (Flat steel products and semi-products)

    UNSPSC Code

    UNSPSC Code 73181108(Tin plating service)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/A0623M-10

    Citation Format

    ASTM A623M-10, Standard Specification for Tin Mill Products, General Requirements [Metric], ASTM International, West Conshohocken, PA, 2010,

    Back to Top