SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|25||$78.00||  ADD TO CART|
1.1 This specification covers a group of common requirements which, unless otherwise specified in the purchase order or in an individual specification, shall apply to tin mill products.
1.2 In case of conflict in requirements, the requirements of the purchase order, the individual material specification,and this general specification shall prevail in the sequence named.
1.3 The following safety hazards caveat pertains to Annex A1 through Annex A8 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1—A complete inch-pound companion to Specification A623M has been developed—A623; therefore, no inch-pound equivalents are presented.
Note 1—A complete inch-pound companion to Specification A623M has been developed—A623; therefore, no inch-pound equivalents are presented.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
A700 Practices for Packaging, Marking, and Loading Methods for Steel Products for Shipment
A987 Practice for Measuring Shape Characteristics of Tin Mill Products
E18 Test Methods for Rockwell Hardness of Metallic Materials
E112 Test Methods for Determining Average Grain Size
Military StandardsMIL-STD-163 Steel Mill Products, Preparation for Marking and Storage
Federal StandardFed. Std. No. 123 Marking for Shipment (Civil Agencies)
ICS Number Code 77.140.50 (Flat steel products and semi-products)
UNSPSC Code 73181108(Tin plating service)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM A623M-09, Standard Specification for Tin Mill Products, General Requirements [Metric], ASTM International, West Conshohocken, PA, 2009, www.astm.orgBack to Top