SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|3||$48.00||  ADD TO CART|
1.1 This specification covers hot-finished or cold-finished bars, except bars for forging (Note 1). It includes rounds, squares, and hexagons in the more commonly used types of stainless free-machining steels designed especially for optimum machinability and for general corrosion and high-temperature service. Stainless steel bars other (Note 2) than the free-machining types are covered in a separate specification.
1.2 The values stated in either inch-pound units or SI (metric) units are to be regarded separately as standard: within the text and tables, the SI uits are shown in [brackets]. The values stated in each system are not exact equivalents: therefore, each system must be used independent of the other. Combining values from the two systems may result in nonconformance with the specification.
1.3 Unless the order specifies the applicable "M" specification designation, the material shall be furnished to the inch-pound units.
Note 1—For bars for reforging, see Specification A314.
Note 2—For non-free machining stainless bars, see Specification A276.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A276 Specification for Stainless Steel Bars and Shapes
A314 Specification for Stainless Steel Billets and Bars for Forging
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
A484/A484M Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings
A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products
A959 Guide for Specifying Harmonized Standard Grade Compositions for Wrought Stainless Steels
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
SAE DocumentSAE J1086 Recommended Practice for Numbering Metals and Alloys
ICS Number Code 77.140.60 (Steel bars and rods)
UNSPSC Code 30264500(Stainless steel bars)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM A582 / A582M-05, Standard Specification for Free-Machining Stainless Steel Bars, ASTM International, West Conshohocken, PA, 2005, www.astm.orgBack to Top