ASTM A467/A467M-01(2006)

    Standard Specification for Machine and Coil Chain

      Format Pages Price  
    PDF 4 $48.00   ADD TO CART

    1. Scope

    1.1 This specification covers welded carbon steel machine chain and coil chain. Although these chains are not intended for pocket wheel use, they can be used for pocket and sprocket wheel use. This chain shall never be used for overhead lifting applications.

    1.2 There are two classes each of machine and coil chain:

    1.2.1 Class MS—Machine, straight-link steel chain,

    1.2.2 Class MT—Machine, twist-link steel chain,

    1.2.3 Class CS—Coil, straight-link chain, and

    1.2.4 Class CT—Coil, twist-link steel chain.

    1.3 The values stated in either inch-pound units or SI units shall be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products

    ICS Code

    ICS Number Code 21.220.30 (Chain drives and their components)

    UNSPSC Code

    UNSPSC Code 31151607(Coil chains)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/A0467_A0467M-01R06

    Citation Format

    ASTM A467 / A467M-01(2006), Standard Specification for Machine and Coil Chain, ASTM International, West Conshohocken, PA, 2006,

    Back to Top