Standard Historical Last Updated: Nov 03, 2017 Track Document
ASTM A387/A387M-17

Standard Specification for Pressure Vessel Plates, Alloy Steel, Chromium-Molybdenum

Standard Specification for Pressure Vessel Plates, Alloy Steel, Chromium-Molybdenum A0387_A0387M-17 ASTM|A0387_A0387M-17|en-US Standard Specification for Pressure Vessel Plates, Alloy Steel, Chromium-Molybdenum Standard new BOS Vol. 01.04 Committee A01
$ 75.00 In stock

Abstract

This specification covers chromium-molybdenum alloy steel plates for welded broilers and pressure vessels designed for elevated temperature service. Materials considered under this specification are available in grades 2, 12, 11, 22, 22L, 21, 21L, 5, 9 and 91. The steel materials shall be killed and shall be thermally treated. The steel specimens shall undergo heat analysis and product analysis and shall conform to the chemical requirements for carbon, manganese, phosphorus, sulfur, silicon, chromium, molybdenum, nickel, vanadium, columbium, boron, nitrogen, aluminum, titanium, and zirconium. The steel specimens shall also undergo tension tests and shall conform to the required values of tensile strength, yield strength, and elongation.

Scope

1.1 This specification2 covers chromium-molybdenum alloy steel plates intended primarily for welded boilers and pressure vessels designed for elevated temperature service.

1.2 Plates are available under this specification in several grades having different alloy contents as follows:

Nominal

Nominal

Chromium

Molybdenum

Grade

Content, %

Content, %

  2

0.50

0.50

 12

1.00

0.50

 11

1.25

0.50

 22, 22L

2.25

1.00

 21, 21L

3.00

1.00

  5

5.00

0.50

  9

9.00

1.00

 91

9.00

1.00

1.3 Each grade except Grades 21L, 22L, and 91 is available in two classes of tensile strength levels as defined in the Tensile Requirements tables. Grades 21L and 22L are available only as Class 1. Grade 91 is available only as Class 2.

Note 1: Grade 911, previously covered by this specification, is now covered by Specification A1017/A1017M.

1.4 The maximum thickness of plates is limited only by the capacity of the composition to meet the specified mechanical property requirements.

1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents. Therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 01.04
Developed by Subcommittee: A01.11
Pages: 6
DOI: 10.1520/A0387_A0387M-17
ICS Code: 77.140.30