Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM A27/A27M-05

Standard Specification for Steel Castings, Carbon, for General Application

Standard Specification for Steel Castings, Carbon, for General Application A0027_A0027M-05 ASTM|A0027_A0027M-05|en-US Standard Specification for Steel Castings, Carbon, for General Application Standard new BOS Vol. 01.02 Committee A01
$ 66.00 In stock

Abstract

This specification covers carbon steel castings for general applications. The grades of steels covered here are: Grade N-1, Grade N-2, Grade U-60-30 [415-205], Grade 60-30 [415-205], Grade 65-35 [450-240], Grade 70-36 [485-250] and Grade 70-40 [485-275]. Except for Grades N-1 and U-60-30, all steel castings shall be heat-treated by full annealing, normalizing, normalizing and tempering, or quenching and tempering. Heat treatments shall be performed after castings have been allowed to cool. Heat and product analyses shall be performed wherein specimens shall conform to required chemical composition of carbon, manganese, silicon, sulfur and phosphorus. Except for Grades N-1 and N-2, all steels shall undergo tension test, and shall conform to the following mechanical requirements: tensile strength, yield point, elongation, and reduction of area.

Scope

1.1 This specification covers carbon steel castings for general applications that require up to 70 ksi [485 MPa] minimum tensile strength.

Note 1—The grades covered by this specification represent materials that are suitable for assembly with other steel castings or wrought steel parts by fusion welding. It is not intended to imply that all these grades possess the same degree of weldability or that the same welding techniques can be used on all castings. It is the responsibility of the purchaser to establish for himself a suitable welding technique.

1.2 Several grades and two classes of steel castings are covered, as indicated below. The grade and class desired shall be specified by the purchaser.

1.2.1 Grade N-1Chemical analysis only.

1.2.2 Grade N-2Heat-treated but not mechanically tested.

1.2.3 Grade U-60-30 [415-205]Mechanically tested but not heat-treated.

1.2.4 Grades 60-30 [415-205], 65-35 [450-240], 70-36[485-250], and 70-40 [485-275]-Heat-treated and mechanically tested.

1.2.5 Class 1 and Class 2 steel castings shall be specified in accordance with .

1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. Inch-pound units are applicable for material ordered to Specification A 27 and SI units for material ordered to Specification A 27M.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 01.02
Developed by Subcommittee: A01.18
Pages: 4
DOI: 10.1520/A0027_A0027M-05
ICS Code: 77.140.80