SUPERSEDED (click for Active standard)
  | Format | Pages | Price |   |
![]() |
3 | $54.00 | ![]() |
1. Scope
1.1 This specification covers material in mat (or sheet) form fabricated from deformed steel bars to be used for the reinforcement of concrete. Mats consist of two layers of bars that are assembled at right angles to each other. Mats are assembled by welding at the intersections.
1.2 This specification is applicable for orders in either inch-pound units (as Specification A 184) or SI units (as Specification A 184M).
1.3 The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
U.S. Federal Standard
Fed Std No. 123 Marketing for Shipments (Civil Agencies)U.S. Military Standard
MIL-STD-129 Marking for Shipment and StorageAWS Standard
AWS D1.4/D1.4M Structural Welding Code Steel Reinforcing BarsASTM Standards
A615/A615M Specification for Deformed and Plain Carbon-Steel Bars for Concrete Reinforcement
A706/A706M Specification for Deformed and Plain Low-Alloy Steel Bars for Concrete Reinforcement
ICS Code
ICS Number Code 77.140.15 (Steels for reinforcement of concrete)
UNSPSC Code
UNSPSC Code 30103623(Reinforcing bar or rebar or mesh)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/A0184_A0184M-06
Citation Format
ASTM A184 / A184M-06, Standard Specification for Welded Deformed Steel Bar Mats for Concrete Reinforcement, ASTM International, West Conshohocken, PA, 2006, www.astm.org
Back to Top