Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM A109/A109M-03

Standard Specification for Steel, Strip, Carbon (0.25 Maximum Percent), Cold-Rolled

Standard Specification for Steel, Strip, Carbon (0.25 Maximum Percent), Cold-Rolled A0109_A0109M-03 ASTM|A0109_A0109M-03|en-US Standard Specification for Steel, Strip, Carbon (0.25 Maximum Percent), Cold-Rolled Standard new BOS Vol. 01.03 Committee A01
$ 75.00 In stock

Abstract

This specification covers cold-rolled carbon steel strip in cut lengths or coils, furnished to closer tolerances than cold-rolled carbon steel sheet. The steel shall be made by the open-hearth, basic-oxygen, or electric-furnace process. Cold-rolled carbon strip specified to temper numbers shall conform to the Rockwell hardness requirements. Bend tests shall be conducted in accordance with requirements specified.

Scope

1.1 This specification covers cold-rolled carbon steel strip in cut lengths or coils, furnished to closer tolerances than cold-rolled carbon steel sheet, with specific temper, with specific edge or specific finish, and in sizes as follows:

Width, in. Thickness, in.
Over 1/2 to 2315/16 0.300 and under
Over 12.5 to 600 mm7.6 mm and under

1.2 Cold-rolled strip is produced with a maximum specified carbon not exceeding 0.25 percent.

1.3 Strip tolerance products may be available in widths wider than 2315/16 in. [600 mm] by agreement between purchaser and supplier. However, such products are technically classified as cold rolled sheet. This specification does not include cold-rolled carbon spring steel, Specification A 682/A 682M. The tolerances, finishes, tempers, edges, and available widths and thicknesses differentiate cold rolled strip from the product known as cold rolled sheet which is defined by Specification A 568/A 568M and Specification A 682/A 682M.

1.4 For the purpose of determining conformance with this specification, values shall be rounded to the nearest unit in the right hand place of figures used in expressing the limiting values in accordance with the rounding method of Practice E 29.

1.5 The SI portions of the tables contained herein list permissible variations in dimensions and mass (see Note 0) in SI (metric) units. The values listed are not exact conversions of the values listed in the inch-pound tables, but instead are rounded or rationalized values. Conformance to SI tolerances is mandatory when the "M" specification is used.

Note 1—The term weight is used when inch-pound units are the standard. However, under SI the preferred term is mass.

1.6 The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems will result in nonconformance with the specification.

1.7 This specification is expressed in both inch-pound units and SI units. However, unless the order specifies the applicable "M" specification designation (SI units), the material shall be furnished to inch-pound units.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 01.03
Developed by Subcommittee: A01.19
Pages: 9
DOI: 10.1520/A0109_A0109M-03
ICS Code: 77.140.50