ASTM A1025-05

    Standard Specification for Ferroalloys, General Requirements

      Format Pages Price  
    PDF 4 $49.20   ADD TO CART

    1. Scope

    1.1 This specification covers a group of common requirements that, unless otherwise specified in an individual specification, shall apply to ferroalloys and other alloying materials under each of the following ASTM specifications:

    1.2 This specification also covers a group of supplementary requirements which may be applied to the above specifications as indicated therein. These are provided for use when additional testing or inspection is desired and apply only when specified individually by the purchaser in the order.

    1.3 In case of conflict between the requirements of the individual specification and this general specification, the former shall prevail.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A99 Specification for Ferromanganese

    A100 Specification for Ferrosilicon

    A101 Specification for Ferrochromium

    A102 Specification for Ferrovanadium

    A132 Specification for Ferromolybdenum

    A146 Specification for Molybdenum Oxide Products

    A323 Specification for Ferroboron

    A324 Specification for Ferrotitanium

    A481 Specification for Chromium Metal

    A482 Specification for Ferrochrome-Silicon

    A483 Specification for Silicomanganese

    A495 Specification for Calcium-Silicon Alloys

    A550 Specification for Ferrocolumbium

    A601 Specification for Electrolytic Manganese Metal

    A610 Test Methods for Sampling and Testing Ferroalloys for Determination of Size

    A636 Specification for Nickel Oxide Sinter

    A701 Specification for Ferromanganese-Silicon

    A845 Specification for Titanium Scrap for Use in Deoxidation and Alloying of Steel

    A846 Specification for Aluminum Scrap for Use in Deoxidation and Alloying of Steel

    A922 Specification for Silicon Metal

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

    E32 Practices for Sampling Ferroalloys and Steel Additives for Determination of Chemical Composition

    ICS Code

    ICS Number Code 77.100 (Ferroalloys)

    UNSPSC Code

    UNSPSC Code

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/A1025-05

    Citation Format

    ASTM A1025-05, Standard Specification for Ferroalloys, General Requirements, ASTM International, West Conshohocken, PA, 2005,

    Back to Top