Standard Active Last Updated: Dec 13, 2023 Track Document
ASTM E2202-23

Standard Practice for Measurement of Equipment-Generated Continuous Noise for Assessment of Health Hazards

Standard Practice for Measurement of Equipment-Generated Continuous Noise for Assessment of Health Hazards E2202-23 ASTM|E2202-23|en-US Standard Practice for Measurement of Equipment-Generated Continuous Noise for Assessment of Health Hazards Standard new BOS Vol. 04.06 Committee E33
$ 63.00 In stock
ASTM International

Significance and Use

5.1 This standard defines measurement procedures for estimating the risk of noise-induced hearing loss among users of noise producing equipment. It is applicable to ground vehicles, aircraft, watercraft, and mobile, transportable, and stationary equipment. The primary approach is to separately measure the sound level at operator ear locations for each normal operating condition. These levels can be combined with operational use scenarios and exposure criteria to define noise exposure severity. The data can also be used to define hearing protection requirements or administrative controls to preclude hearing hazards.

5.2 The practice has the following limitations:

5.2.1 The practice uses field portable measurement equipment.

5.2.2 The practice produces data which may be compared with applicable criteria or limits if the limits are in terms of the quantities measured in this standard or which can be calculated from the measured data.

Scope

1.1 This standard defines noise measurement procedures for estimating the risk of hearing loss among users of noise producing equipment. It is applicable to ground vehicles, aircraft, watercraft, and other mobile, transportable, or stationary equipment.

1.2 This standard does not recommend noise exposure limit levels or criteria for any application discussed.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.06
Developed by Subcommittee: E33.08
Pages: 5
DOI: 10.1520/E2202-23
ICS Code: 17.140.01