Standard Active Last Updated: Nov 17, 2021 Track Document
ASTM D5665/D5665M-99a(2021)

Standard Specification for Thermoplastic Fabrics Used in Cold-Applied Roofing and Waterproofing

Standard Specification for Thermoplastic Fabrics Used in Cold-Applied Roofing and Waterproofing D5665_D5665M-99AR21 ASTM|D5665_D5665M-99AR21|en-US Standard Specification for Thermoplastic Fabrics Used in Cold-Applied Roofing and Waterproofing Standard new BOS Vol. 04.04 Committee D08
$ 55.00 In stock

Abstract

This specification covers thermoplastic fabrics such as polyester, polyester/polyamide bicomponent, or composites with fiberglass or polyester scrims that can be used during the construction of cold-applied roofing and waterproofing. The thermoplastic fabrics shall be classified as: Type I; Type II; Type III; Type IV; Type V; Type VI; and Type VII. Fabrics shall conform to the thickness, mass, and physical properties specified. Tests shall be performed to determine the properties of the material in accordance with the following test methods: unit mass; thickness; breaking load and elongation; trapezoid tearing strength; and puncture strength.

Scope

1.1 This specification covers thermoplastic fabrics such as polyester, polyester/polyamide bicomponent, or composites with fiberglass or polyester scrims that can be used during the construction of cold-applied roofing and waterproofing.

1.2 This specification is intended as a material specification. Issues regarding the suitability of specific roof constructions or application techniques are beyond the scope of this specification.

1.3 The specified tests and property values used to characterize the respective fabrics are intended to establish minimum properties. In-place system design criteria or performance attributes are factors beyond the scope of this material specification.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.04
Developed by Subcommittee: D08.04
Pages: 3
DOI: 10.1520/D5665_D5665M-99AR21
ICS Code: 91.100.50