ASTM WK42235

    Work Item: ASTM WK42235 - New Test Method for Efficacy of Copper Alloy Surfaces as a Sanitizer

    (What is a Work Item?)

    Developed by Subcommittee: B05.06 | Committee B05 | Contact Staff Manager



    1. Scope

    1.1 This laboratory test method describes a procedure to evaluate the efficacy of copper and copper alloy surfaces as non-food, contact surfaces as sanitizers. Note 1--This test method, through extensive testing, was used to establish the antimicrobial characteristics of copper alloys, and resulted in the EPA registration of a significant number of alloys. This test method as stated, is how the alloys in the registered list were tested and accepted, but it is not intended for use as a dynamic product qualification test. It is a current, initial efficacy test but may not reflect the most recent developments in laboratory practices. It is a viable, verifiable test method translated from an EPA protocol into ASTM format. 1.2 The use of copper surfaces is a supplement to, and not a substitute for standard infection control practices. The copper surfaces shall be used bare, not coated such as waxed, painted, lacquered, varnished or otherwise coated. 1.3 It is the responsibility of the investigator to determine whether Good Laboratory Practices (GLPs) are required and follow them when appropriate. 1.4 This test method may involve hazardous materials, chemicals, and microorganisms and should be performed only by persons who have had formal microbiological training. 1.5 This standard does not purport to address all safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.6 Units--The units stated in either SI units or inch-pound units are regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

    The document establishes the procedure used to determine the antimicrobial characteristics of copper as it might apply to any touch surface, with the intent of elimination of pathogen contamination of surfaces particularly in health care related environments.


    Keywords

    antimicrobial surface; surface contact infection control

    The title and scope are in draft form and are under development within this ASTM Committee.

    Citing ASTM Standards
    Back to Top
    Work Item Status

    Date Initiated:
    05-23-2013

    Technical Contact:
    Robert Solbach

    Item:
    015

    Ballot:
    B05 (13-02)

    Status:
    Negative Votes Need Resolution