1.1 This specification covers requirements and test methods for materials, workmanship, dimensions, perforations, pipe stiffness, elongation, quality of extruded polyethylene, brittleness, bond, and marking of corrugated polyethylene (PE) pipe. It covers nominal sizes 3 in. (76 mm), 4 in. (102 mm), 5 in. (127 mm), 6 in. (152 mm), 8 in. (203 mm), 10 in. (254 mm), 12 in. (305 mm), 15 in. (381 mm), 18 in. (457 mm), and 24 in. (610 mm). 1.2 This specification covers tubularly extruded, spirally laminated, and rotationally molded corrugated polyethylene pipe. 1.3 Fittings manufactured to meet Specification F667 should be used for this pipe. 1.4 Units--The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 The following precautionary caveat pertains only to the test method portion, Section 9, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
It is a new standard for corrugated pipe with recycled content.
Keywordscorrugated; perforated; polyethylene; underdrain
The title and scope are in draft form and are under development within this ASTM Committee.Back to Top
Negative Votes Need Resolution