ASTM WK37193

    New Practice for Specimen Preparation and Mounting of Plastic Pipe and Plastic Tubing for Building Applications to Assess Surface Burning Characteristics

    (What is a Work Item?)

    Developed by Subcommittee: E05.22 | Committee E05 | Contact Staff Manager



    WK37193

    1. Scope

    1.0SCOPE 1.1This Practice describes a procedure for specimen preparation and mounting when testing plastic pipe and plastic tubing to assess flame spread and smoke development as surface burning characteristics using Test Method E84. 1.2This Practice applies to plastic pipe and plastic tubing. 1.3This Practice presents 3 ways of testing materials; as pipe lengths, as sheets, or as arc sections. 1.4This Practice does not provide pass/fail criteria that can be used as a regulatory tool. 1.5This Practice addresses only pipe profiles and does not address discrete components such as connectors, valves, curved fittings, or other accessories used in pipe installation. 1.6Use the values stated in inch-pound units as the standard in referee decisions. The values in the SI system of units are given in parentheses, for information only; see IEEE/ASTM SI-10 for further details. 1.7This fire standard cannot be used to provide quantitative measures. 1.8 Fire testing of products and materials is inherently hazardous and adequate safeguards for personnel and property shall be employed in conducting these tests. Fire testing involves hazardous materials, operations and equipment. 1.9This Practice gives instructions on specimen preparation and mounting but the fire-test-response method shall be conducted in accordance with Test Method E84. See also Section 8 for information on operator safety. 1.10 The text of this Practice references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered requirements of the standard. 1.11This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    Method needed for testing pipes in ASTM E84


    Keywords

    fire, fire test, flame spread, smoke developed, tunnel, pipe, tubing

    The title and scope are in draft form and are under development within this ASTM Committee.

    Citing ASTM Standards
    Back to Top
    Work Item Status

    Date Initiated:
    04-13-2012

    Technical Contact:
    Marcelo Hirschler

    Item:
    001

    Ballot:
    E05.22 (14-04)

    Status:
    Negative Votes Need Resolution