ASTM G80-88(1998)

    Standard Test Method for Specific Cathodic Disbonding of Pipeline Coatings (Withdrawn 2007)

    Withdrawn Standard: ASTM G80-88(1998) | Developed by Subcommittee: D01.48

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF 5 $51.60   ADD TO CART


    Withdrawn Rationale:

    This test method covers an accelerated procedure for simultaneously determining comparative characteristics of insulating coating systems applied to steel pipe exterior for the purpose of preventing or mitigating corrosion that may occur in underground service where the pipe will be in contact with natural soils and may or may not receive cathodic protection. It is intended for use with samples of coated pipe taken from commercial production and is applicable to such samples when the coating is characterized by function as an electrical barrier.

    Formerly under the jurisdiction of Committee D01 on Paint and Related Coatings, Materials, and Applications, this test method was withdrawn in March 2007 in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

    1. Scope

    1.1 This test method covers an accelerated procedure for simultaneously determining comparative characteristics of insulating coating systems applied to steel pipe exterior for the purpose of preventing or mitigating corrosion that may occur in underground service where the pipe will be in contact with natural soils and may or may not receive cathodic protection. It is intended for use with samples of coated pipe taken from commercial production and is applicable to such samples when the coating is characterized by function as an electrical barrier.

    1.2 This test method is specific with no options. For alternative methods of test see Test Methods G8.

    1.3 The values stated in SI units are to be regarded as the standard.

    1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    G8 Test Methods for Cathodic Disbonding of Pipeline Coatings

    G12 Test Method for Nondestructive Measurement of Film Thickness of Pipeline Coatings on Steel

    G16 Guide for Applying Statistics to Analysis of Corrosion Data


    Referencing This Standard

    DOI: 10.1520/G0080-88R98

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM G80-88(1998), Standard Test Method for Specific Cathodic Disbonding of Pipeline Coatings (Withdrawn 2007), ASTM International, West Conshohocken, PA, 1998, www.astm.org

    Back to Top