ASTM G19-04

    Standard Test Method for Disbonding Characteristics of Pipeline Coatings by Direct Soil Burial (Withdrawn 2010)

    Withdrawn Standard: ASTM G19-04 | Developed by Subcommittee: D01.48

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF 4 $45.60   ADD TO CART


    Withdrawn Rationale:

    This test method describes the determination of the relative disbonding characteristics of damaged coatings on steel pipe by cathodic protection potentials in direct soil burial. This test method is intended to apply to the testing of all types of nonmetallic pipeline coatings and tapes including thermoplastics, thermoset, and bituminous materials.

    Formerly under the jurisdiction of Committee D01 on Paint and Related Coatings, Materials, and Applications this test method was withdrawn in June 2010. This standard is being withdrawn without replacement due to its limited use by industry.

    1. Scope

    1.1 This test method describes the determination of the relative disbonding characteristics of damaged coatings on steel pipe by cathodic protection potentials in direct soil burial. This test method is intended to apply to the testing of all types of nonmetallic pipeline coatings and tapes including thermoplastics, thermoset, and bituminous materials.

    1.2 Results may vary widely when test sites are in different geographical areas of the country, and even in different localities.

    1.3 This test method is limited to nonconducting, or nonmetallic pipe coatings and is not applicable to conducting materials such as zinc coatings on steel pipe.

    1.4 The values stated in SI units to three significant decimals are to be regarded as the standard. The values given in parentheses are for information only.

    This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    G12 Test Method for Nondestructive Measurement of Film Thickness of Pipeline Coatings on Steel

    G62 Test Methods for Holiday Detection in Pipeline Coatings


    Referencing This Standard

    DOI: 10.1520/G0019-04

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM G19-04, Standard Test Method for Disbonding Characteristics of Pipeline Coatings by Direct Soil Burial (Withdrawn 2010), ASTM International, West Conshohocken, PA, 2004, www.astm.org

    Back to Top