WITHDRAWN, NO REPLACEMENT
| ||Format||Pages||Price|| |
|3||$48.00||  ADD TO CART|
This guide covers the basic tests which shall be conducted on amusement rides and devices during prototype development, installation or erection, following major modifications, and during normal operation to determine that the performance of a given ride or device meets the manufacturer’s specified design criteria.
Formerly under the jurisdiction of Committee F24 on Amusement Rides and Devices, this guide was withdrawn without replacement in August 2013 because information contained within this standard can be found in other F24 standards.
1.1 This guide covers the basic tests which shall be conducted on amusement rides and devices during prototype development, installation or erection, following major modifications, and during normal operation to determine that the performance of a given ride or device meets the manufacturer's specified design criteria.
Note 1—The following standards developed by Committee F24 contain information relative to this guide: Specification F 698
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
E543 Specification for Agencies Performing Nondestructive Testing
E1212 Practice for Quality Management Systems for Nondestructive Testing Agencies
E1316 Terminology for Nondestructive Examinations
F698 Specification for Physical Information to be Provided for Amusement Rides and Devices
F747 Terminology Relating to Amusement Rides and Devices
F770 Practice for Ownership, Operation, Maintenance, and Inspection of Amusement Rides and Devices
F853 Practice for Maintenance Procedures for Amusement Rides and Devices
F1193 Practice for Quality, Manufacture, and Construction of Amusement Rides and Devices
ASNT DocumentRecommended Practice SNT-TC-1A Personnel Qualification and Certification in Nondestructive Testing
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM F846-92(2009), Standard Guide for Testing Performance of Amusement Rides and Devices (Withdrawn 2013), ASTM International, West Conshohocken, PA, 2009, www.astm.orgBack to Top