ASTM F745-07

    Withdrawn Standard: ASTM F745-07 Standard Specification for 18 Chromium-12.5 Nickel-2.5 Molybdenum Stainless Steel for Cast and Solution-Annealed Surgical Implant Applications (Withdrawn 2012)

    Developed by Subcommittee: F04.12

    WITHDRAWN, NO REPLACEMENT

    Buy Standard (PDF)
    3 pages
    $44.40


    Withdrawn Rationale:

    This specification covers the requirements for 18chromium-12.5nickel-2.5molybdenum stainless steel alloy shot, bar, or ingot used for the manufacture of cast and solution-annealed surgical implants. This material is known to be paramagnetic.

    Formerly under the jurisdiction of Committee F04 on Medical and Surgical Materials and Devices, this specification was withdrawn in September 2012 due to lack of use.

    1. Scope

    1.1 This specification covers the requirements for 18chromium-12.5nickel-2.5molybdenum stainless steel alloy shot, bar, or ingot used for the manufacture of cast and solution-annealed surgical implants.

    1.2 The values stated in inch-pound units are to be regarded as the standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A800/A800M Practice for Steel Casting, Austenitic Alloy, Estimating Ferrite Content Thereof

    A957 Specification for Investment Castings, Steel and Alloy, Common Requirements, for General Industrial Use

    E8 Test Methods for Tension Testing of Metallic Materials

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

    E353 Test Methods for Chemical Analysis of Stainless, Heat-Resisting, Maraging, and Other Similar Chromium-Nickel-Iron Alloys

    Aerospace Material Specifications

    AMS2248 Chemical Check Analysis Limits, Corrosion and Heat Resistant Steels and Alloys, Maraging and Other Highly-Alloyed Steels, and Iron Alloys

    ISO Standards

    ISO9001 Quality Management Systems--Requirements

    American Society for Quality (ASQ) Standard

    ASQC1 Specification of General Requirements for a Quality Program


    DOI: 10.1520/F0745-07

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top