ASTM F405 - 13

    Standard Specification for Corrugated Polyethylene (PE) Pipe and Fittings

    Active Standard ASTM F405 | Developed by Subcommittee: F17.65

    Book of Standards Volume: 08.04


    Buy Standard (PDF)
    5 pages
    $42.00
    Buy Standard (Print)
    5 pages
    $42.00
    Buy Standard + Redline (PDF)
    10 pages
    $50.40

    Historical (view previous versions of standard)


    ASTM F405

    Abstract

    This specification covers the physical and dimensional requirements and associated test methods for corrugated polyethylene (PE) pipe and fittings intended for underground applications, particularly in soil drainage and septic field leach beds, where soil support is given to the flexible walls. Pipe and fittings shall adhere to physical test requirements such as elongation, brittleness, pipe stiffness, and perforations.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers requirements and test methods for materials, marking dimensions, workmanship, elongation, brittleness, pipe stiffness, and perforations for corrugated polyethylene (PE) pipe and fittings in nominal sizes of 3 to 6 in., inclusive.

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard..

    Note 1Along with sizes 3 to 6 in. covered in this specification, sizes 4 to 24 in. are described in Specification F667.

    1.3 The text of this specification references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.

    1.4 The following precautionary caveat pertains only to the test methods portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D618 Practice for Conditioning Plastics for Testing

    D1600 Terminology for Abbreviated Terms Relating to Plastics

    D2122 Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings

    D2412 Test Method for Determination of External Loading Characteristics of Plastic Pipe by Parallel-Plate Loading

    D3350 Specification for Polyethylene Plastics Pipe and Fittings Materials

    F412 Terminology Relating to Plastic Piping Systems

    F667 Specification for 3 through 24 in. Corrugated Polyethylene Pipe and Fittings


    ICS Code

    ICS Number Code 23.040.20 (Plastic pipes); 23.040.45 (Plastic fittings)

    UNSPSC Code

    UNSPSC Code


    DOI: 10.1520/F0405

    ASTM International is a member of CrossRef.

    ASTM F405

    Citing ASTM Standards
    Back to Top