ASTM F3009 - 14

    Standard Specification for Polyolefin Composition Floor Tile

    Active Standard ASTM F3009 | Developed by Subcommittee: F06.80

    Book of Standards Volume: 15.04


    Buy Standard (PDF)
    4 pages
    $37.00
    Buy Standard (Print)
    4 pages
    $37.00


    ASTM F3009

    Abstract

    This specification is intended for polyolefin composition tile with either smooth or embossed surfaces flooring application for use in commercial, light commercial or residential surfaces flooring application. It covers a tile that is composed of binder, fillers and pigments. The binder consists of one or more resins of polyolefin, polyolefin copolymers or polyolefin ter-polymers (or other suitable), or any desirable combination. Other suitable polymeric resins may be incorporated as part of the binder provided the polyolefin portion of the binder system is greater than 50 %. This specification covers materials and manufacture, physical properties, mechanical properties, performance requirements, sampling, and inspection.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers polyolefin composition tile with either smooth or embossed surfaces flooring application for use in commercial, light commercial or residential surfaces flooring application.

    1.2 This specification covers a tile that shall be composed of binder, fillers and pigments. The binder shall consist of one or more resins of polyolefin, polyolefin copolymers or polyolefin ter-polymers (or other suitable), or any desirable combination. Other suitable polymeric resins may be incorporated as part of the binder provided the polyolefin portion of the binder system is greater than 50 %.

    1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D883 Terminology Relating to Plastics

    F141 Terminology Relating to Resilient Floor Coverings

    F386 Test Method for Thickness of Resilient Flooring Materials Having Flat Surfaces

    F925 Test Method for Resistance to Chemicals of Resilient Flooring

    F1265 Test Method for Resistance to Impact for Resilient Floor Tile

    F1304 Test Method for Deflection of Resilient Floor Tile

    F1514 Test Method for Measuring Heat Stability of Resilient Flooring by Color Change

    F1515 Test Method for Measuring Light Stability of Resilient Flooring by Color Change

    F1914 Test Methods for Short-Term Indentation and Residual Indentation of Resilient Floor Covering

    F2055 Test Method for Size and Squareness of Resilient Floor Tile by Dial Gage Method

    F2199 Test Method for Determining Dimensional Stability of Resilient Floor Tile after Exposure to Heat

    Other Standards

    ANSI/ASQCZ1.4 (most recent version)-Sampling Procedures and Tables for Inspection by Attributes


    DOI: 10.1520/F3009

    ASTM International is a member of CrossRef.

    ASTM F3009

    Citing ASTM Standards
    Back to Top