1. Scope
1.1 This specification covers the male threaded connection used to connect a CO2 Control Valve or Compressed Air Regulator with an output pressure of 10 342 kPa (1800 psig) or less for use with a paintball marker to a DOT approved cylinder.
1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Code of Federal Regulations
DOTCFFC4thRevision
ANSI Standards
ANSIY14.5M–199 Dimensioning and Tolerancing
Federal Standards
NBSHandbookH-28
CGA Standards
CGAS-1.1 Pressure Relief Device Standards-Part 1-Cylinders for Compressed Gases
Military Standards
MS28775 Packing, Preformed, Hydraulic, +275 Deg. F (O-Ring)
ASTM Standards
D2240 Test Method for Rubber Property--Durometer Hardness
F1750 Specification for Paintball Marker Threaded-Propellant Source Interface
F2030 Specification for Paintball Cylinder Burst Disk Assemblies
Index Terms
burst disc; paintball marker; paintball sports; Paintball sports--specifications; Compressed air ;
ICS Code
ICS Number Code 23.060.40 (Pressure regulators)
DOI: 10.1520/F2653-11
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
