ASTM F2507 - 05(2010)

    Standard Specification for Recreational Airpark Design

    Active Standard ASTM F2507 | Developed by Subcommittee: F37.70

    Book of Standards Volume: 15.11


      Format Pages Price  
    PDF 6 $43.00   ADD TO CART
    Hardcopy (shipping and handling) 6 $43.00   ADD TO CART


    Abstract

    This specification covers the minimum requirements for the design of a recreational airpark intended to service any aircraft with specified stall speed. Recreational Airparks may provide commercial services in support of the recreational operation of light sport aircraft, including, but not limited to: flight instruction, introductory flights, aircraft rental, glider towing, and maintenance services. An airpark site should take into consideration the need to ensure safe approaches and departures of aircraft. Each facility shall have a means by which a person can contact an appropriate authority in case of an emergency. One example would be a public phone. Each facility shall have a functioning wind sock. Runway location and orientation are important to airport safety, efficiency, economics, and environmental impact. The threshold should be located at the beginning of the marked runway surface. Fuel storage facilities are required to be placed in a location outside of the runway and taxiway safety areas.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers the minimum requirements for the design of a recreational airpark intended to service any aircraft with stall speeds (Vs1) of 45 knots or less. These aircraft include but are not limited to, standard category aircraft, light sport aircraft, ultralights, microlights, and advanced ultralights

    1.2 Recreational airparks are designed for daylight operations from 60 min before official sunrise to 60 min after official sunset.

    1.3 Recreational Airparks may provide commercial services in support of the recreational operation of light sport aircraft, including, but not limited to: flight instruction, introductory flights, aircraft rental, glider towing, and maintenance services.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D4814 Specification for Automotive Spark-Ignition Engine Fuel

    D6227 Specification for Unleaded Aviation Gasoline Containing a Non-hydrocarbon Component

    F2244 Specification for Design and Performance Requirements for Powered Parachute Aircraft

    F2245 Specification for Design and Performance of a Light Sport Airplane

    F2317/F2317M Specification for Design of Weight-Shift-Control Aircraft

    F2352 Specification for Design and Performance of Light Sport Gyroplane Aircraft

    FAA Standards

    FARPart157 Notification of Construction, Alteration, Activation, and Deactivation of Airports

    NFPA Standard

    NFPAStandardNo.30 Flammable and Combustible Liquids Code


    ICS Code

    ICS Number Code 93.120 (Construction of airports)

    UNSPSC Code

    UNSPSC Code 25130000(Aircraft)


    DOI: 10.1520/F2507-05R10

    ASTM International is a member of CrossRef.

    ASTM F2507

    Citing ASTM Standards
    Back to Top