ASTM F2419 - 11

    Standard Practice for Installation of Thick Poured Gypsum Concrete Underlayments and Preparation of the Surface to Receive Resilient Flooring

    Active Standard ASTM F2419 | Developed by Subcommittee: F06.40

    Book of Standards Volume: 15.04


    Buy Standard (PDF)
    3 pages
    $37.00
    Buy Standard (Print)
    3 pages
    $37.00
    Buy Standard + Redline (PDF)
    6 pages
    $44.40

    Historical (view previous versions of standard)


    ASTM F2419

    Significance and Use

    This practice provides minimum recommendations for the installation of thick poured gypsum concrete floor underlayments suitable to receive resilient floor coverings. This practice establishes the proper preparation, installation and quality control for thick poured gypsum concrete floor underlayments.

    Actual requirements for thick poured gypsum concrete underlayments are generally included as part of project plans or specifications and may vary from the recommendations set forth in this practice. Project plans or specifications, or both, shall supersede the recommendations set forth in this practice.

    1. Scope

    1.1 This practice covers the installation and preparation of the thick poured gypsum concrete underlayments over wood structural panel subfloors in commercial structures or over concrete floors in commercial structures and the preparation of the thick poured gypsum concrete underlayment surface prior to the installation of resilient flooring in commercial buildings.

    1.2 This practice covers the factors that are required to be controlled while installing thick poured gypsum concrete underlayment as a base for resilient flooring.

    1.3 This practice does not cover the structural adequacy of the wood structural panel subfloor or concrete subfloor. The structural integrity of assemblies is governed by local building codes.

    1.4 This practice does not supersede in any manner the thick poured gypsum concrete underlayment manufacturers, adhesive manufacturers or resilient flooring manufacturers written instructions. Consult the individual manufacturer for specific recommendations.

    1.5 Thick poured gypsum concrete underlayments are not suitable for use on concrete slabs on ground due to potential moisture problems arising from moisture intrusion, unless an adequate vapor retarder or vapor barrier is present directly beneath the concrete subfloor.

    1.6 The values stated in inch-pound units are to be regarded as standard. The values stated in parentheses are approximate mathematical conversions to SI units, which are provided for information only.

    1.7 This practice may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    C472 Test Methods for Physical Testing of Gypsum, Gypsum Plasters and Gypsum Concrete

    D4263 Test Method for Indicating Moisture in Concrete by the Plastic Sheet Method

    F141 Terminology Relating to Resilient Floor Coverings

    F1482 Practice for Installation and Preparation of Panel Type Underlayments to Receive Resilient Flooring


    ICS Code

    ICS Number Code 91.180 (Interior finishing)

    UNSPSC Code

    UNSPSC Code 30111500(Concrete and mortars); 30161700(Flooring)


    DOI: 10.1520/F2419-11

    ASTM International is a member of CrossRef.

    ASTM F2419

    Citing ASTM Standards
    Back to Top