These test methods cover the testing of fine wire, flat or round, approximately 0.010 in. (0.25 mm) and smaller in diameter or thickness, used in electronic devices and lamps. Chemical analysis of the material shall be made in accordance with the requirements prescribed. The procedures in determining the out-of-roundness, edgewise curvature of ribbon, and straightness of straightened round wire are presented in details. Tension test and electrical resistivity test shall be performed to meet the requirements prescribed.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 These test methods cover the testing of fine wire, flat or round, approximately 0.010 in. (0.25 mm) and smaller in diameter or thickness, used in electronic devices and lamps.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

B63 Test Method for Resistivity of Metallically Conducting Resistance and Contact Materials

D374 Test Methods for Thickness of Solid Electrical Insulation

F16 Test Methods for Measuring Diameter or Thickness of Wire and Ribbon for Electronic Devices and Lamps

F205 Test Method for Measuring Diameter of Fine Wire by Weighing

F289 Specification for Molybdenum Wire and Rod for Electronic Applications

Keywords

electrical resistance; electron devices; lamps; round and flat wire; tensile testing; Electrical conductor wire; Electrical resistance/resistivity--semiconductors; Electron tubes--wire; Elongation; Flashlamps (gas-filled); Lamps; Metal electronic components/devices; Out-of-roundness; Straightness; Tensile properties/testing--electronic materials/applications; Wire--electronic devices;

ICS Code

ICS Number Code 29.060.10 (Wires)

Citing ASTM Standards

[Back to Top]