Standards

ASTM F2167 - 12a


ASTM F2167 - 12a Standard Consumer Safety Specification for Infant Bouncer Seats


Active Standard ASTM F2167 Developed by Subcommittee: F15.21 |Book of Standards Volume: 15.11

more info 10 pages $ 41.00
more info 10 pages $ 41.00
why redline? 20 pages $ 49.20

Historical (view previous versions of standard) ASTM License Agreement Shipping & Handling

More F15.21 Standards Related Products
Find Labs Copyright/Permissions Standard References

ASTM F2167

1. Scope

1.1 This consumer safety specification covers establishment of requirements, test methods, and marking requirements to promote safe use of an infant bouncer seat by an occupant and a caregiver.

1.2 For purposes of this consumer safety specification, an infant bouncer seat is a freestanding product intended to support an occupant in a reclined position to facilitate bouncing by the occupant, with the aid of a caregiver or by other means. Intended occupants are infants who have not developed the ability to sit up unassisted (approximately 0 to 6 months of age).

1.3 This consumer safety specification is intended to minimize the risk of injury to an occupant resulting from normal use and reasonably foreseeable misuse or abuse of an infant bouncer seat.

1.4 No infant bouncer seat produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein.

1.5 This consumer safety specification is not intended to address incidents and injuries resulting from the interaction of other persons with the occupant in an infant bouncer seat or the incidents resulting from abuse or misuse by other children.

1.6 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.7 The following precautionary caveat pertains only to the test method portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.


FIG. 1 CAMI Infant Dummy, Mark II (17.5 lb, 8.0 kg)


FIG. 2 CAMI Newborn Dummy (7.5 lb, 3.4 kg)


2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

D3359 Test Methods for Measuring Adhesion by Tape Test
F404 Consumer Safety Specification for High Chairs
F833 Consumer Safety Performance Specification for Carriages and Strollers
F963 Consumer Safety Specification for Toy Safety
F2050 Consumer Safety Specification for Hand-Held Infant Carriers

Federal Regulations

16CFR1501 Method for Identifying Toys and Other Articles Intended for Use by Children Under Three Years of Age Which Present Choking, Aspiration or Ingestion Hazards Because of Small Parts

Other References

CAMINewbornDummy (see )


Keywords

bouncing motion; caregiver facilitated action ; infant seat;



ICS Code

ICS Number Code 97.190 (Equipment for children)



DOI: 10.1520/F2167-12A

ASTM International is a member of CrossRef.


Citing ASTM Standards

[Back to Top]

Standards Tracker

Standards Subscriptions


Related Standards:
F1235
F2050
F2012
F2236
F2640
See All