Active Standard ASTM F1923 | Developed by Subcommittee: F09.20
Book of Standards Volume: 09.02
Historical (view previous versions of standard)
Significance and Use
4.1 This test method establishes a standard procedure of comparative testing, for tire strength and dimensional characteristics, for use under the Administrator's Cooperative Approved Tire List (CATL) (2).
1.1 This test method covers measurements for comparative tire strength and dimensional characteristics. This test method covers new and retreaded pneumatic tires, both tube and tubeless types, and flaps when applicable, for mounting on construction, earthmoving, mining and logging equipment, graders, mobile cranes, and similar vehicles operated at low speeds off the road.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D412 Test Methods for Vulcanized Rubber and Thermoplastic Elastomers--Tension
F538 Terminology Relating to the Characteristics and Performance of Tires
ICS Number Code 83.160.99 (Other tyres)
UNSPSC Code 25172500(Tires and tire tubes)