Abstract
This specification covers the male and female threaded connectors used to interface a propellant source to a paintball marker. The male connector shall incorporate a means for propellant shutoff that shall meet the maximum leakage requirement. When the male and female connectors are joined and pressurized, together they shall meet the maximum leakage specification. The male and female connector shall conform to the physical envelope described. The male connector may contain, as a means of propellant shutoff, a valve core to provide for an automatic shutoff of flow at the time of disconnection. The female connector shall have a provision for the self venting of residual gas pressure prior to the disconnection of the threaded interface.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification covers the male and female threaded connectors used to interface a propellant source with a working pressure of 10 342 kPa (1800 psig) or less to a paintball marker.
1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately)
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ANSI Standard
ANSIY14.5M–199 Dimensioning and Tolerancing
CGA Standard
CGA-320 .825-14NGO-RH-EXT (Flat Nipple)
Federal Standard
FED-STD-H28/9A 24 March 1989 Federal Standard Screw-Thread Standards for Federal Services Section 9 Gas Cylinder Valve Outlet and Inlet Threads
ASTM Standards
D2240 Test Method for Rubber Property--Durometer Hardness
F2272 Specification for Paintball Markers
Military Standard
MS28775 O-Ring Dash Sizes
Index Terms
paintball marker; propellant; Consumer safety specifications (guns); Paintball sports--specifications; Guns; Propellants/projectiles (for guns); Sports equipment--specifications;
ICS Code
ICS Number Code 97.220.99 (Other sports equipment and facilities)
DOI: 10.1520/F1750-11
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]