ASTM F1659-95

    Standard Test Method for Bending and Shear Fatigue Testing of Calcium Phosphate Coatings on Solid Metallic Substrates (Withdrawn 2005)

    Withdrawn Standard: ASTM F1659-95 | Developed by Subcommittee: F04.13

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF 7 $51.60   ADD TO CART


    Withdrawn Rationale:

    This test method covers the procedure for the performance of calcium phosphate ceramic coatings in shear and bending fatigue modes. In the shear fatigue mode this test method evaluates the adhesive and cohesive properties of the coating on a metallic substrate. In the bending fatigue mode, this test method evaluates both the adhesion of the coating as well as the effects that the coating may have on the substrate material. These test methods are limited to testing in air at ambient temperature. These test methods are not intended for application in fatigue tests of components or devices; however, the test method that most closely replicates the actual loading configuration is preferred.

    Formerly under the jurisdiction of Committee F04 on Medical and Surgical Materials and Devices, this test method was withdrawn in August 2005 in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

    1. Scope

    1.1 This test method covers the procedure for the performance of calcium phosphate ceramic coatings in shear and bending fatigue modes. In the shear fatigue mode this test method evaluates the adhesive and cohesive properties of the coating on a metallic substrate. In the bending fatigue mode, this test method evaluates both the adhesion of the coating as well as the effects that the coating may have on the substrate material. These test methods are limited to testing in air at ambient temperature. These test methods are not intended for application in fatigue tests of components or devices; however, the test method that most closely replicates the actual loading configuration is preferred.

    1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    Referencing This Standard

    DOI: 10.1520/F1659-95

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM F1659-95, Standard Test Method for Bending and Shear Fatigue Testing of Calcium Phosphate Coatings on Solid Metallic Substrates (Withdrawn 2005), ASTM International, West Conshohocken, PA, 1995, www.astm.org

    Back to Top