Active Standard ASTM F1567 | Developed by Subcommittee: F25.11
Book of Standards Volume: 01.07
Historical (view previous versions of standard)
This specification covers the material, operating, and testing requirements for automatic or continuously self-cleaning strainers, or both, for use in fuel oil and lubricating oil systems and in any marine environment. The strainer may be either hydraulic, electric, or pneumatic operated, and is designed to operate under positive pressure, that is, on the discharge side of the pump. The strainers should operate at specified pressures, temperatures, shipboard environments, and self-cleaning rates. They shall also undergo flow capacity test, inclined flow capacity test, strength of internals test, and self-cleaning and filtration efficiency test.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1.1 This specification covers automatic or continuously self-cleaning automatic strainers, or both, for use in fuel and lubrication oil systems. The strainer is designed to operate under positive pressure (discharge side of the pump). Strainers manufactured to this specification are suitable for use in any marine environment.
1.2 It is not the intent of this document to redefine existing filtration standards. The intent is to provide sound guidelines for purchasers and designers of lube oil and fuel oil systems. Nominal micron requirements and filter efficiencies shall be as agreed upon by the purchaser and manufacturer and stated in the purchase order document.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D3951 Practice for Commercial Packaging
F795 Practice for Determining the Performance of a Filter Medium Employing a Single-Pass, Constant-Rate, Liquid Test
F1199 Specification for Cast (All Temperatures and Pressures) and Welded Pipe Line Strainers (150 psig and 150F Maximum)
F1200 Specification for Fabricated (Welded) Pipe Line Strainers (Above 150 psig and 150F)
American Welding Society StandardAWSD1.3 Structural Welding Code
MSS StandardsSP55 Quality Standards for Valve, Flanges and Fittings and Other Piping Components (Visual Method)
Military SpecificationsMIL-P-15024/5 Plates, Identification
Military StandardsMIL-STD-2073-1 Material Procedures for Development and Application of Packaging Requirements
ASME/ANSI StandardsY14.5 Dimensioning and Tolerancing
ICS Number Code 21.260 (Lubrication systems)
UNSPSC Code 40170000(Pipe piping and pipe fittings)