ASTM F1377 - 13

    Standard Specification for Cobalt-28Chromium-6Molybdenum Powder for Coating of Orthopedic Implants (UNS R30075)

    Active Standard ASTM F1377 | Developed by Subcommittee: F04.12

    Book of Standards Volume: 13.01


      Format Pages Price  
    PDF 3 $37.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $37.00   ADD TO CART
    Standard + Redline PDF Bundle 6 $44.40   ADD TO CART


    Abstract

    This specification covers the requirements for cobalt-28chromium-6molybdenum alloy powders for coating of orthopedic implants. This specification covers powder requirements only and does not address coating properties. Materials may be manufactured by rotating electrode process, inert gas atomization, or other methods that meet the powder requirements of this specification. The powder shall conform to chemical composition, sieve analysis, and cleanliness requirements of this specification.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    Significance and Use

    1. Scope

    1.1 This specification covers the requirements for cobalt-28chromium-6molybdenum alloy powders for use in fabricating coatings on cobalt-28chromium-6molybdenum alloy orthopedic implants.

    1.2 Powders covered under this specification may be used to form coatings by sintering or thermal spraying techniques.

    1.3 This specification covers powder requirements only. It does not address properties of the coatings formed from them.

    1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B214 Test Method for Sieve Analysis of Metal Powders

    B215 Practices for Sampling Metal Powders

    E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

    E354 Test Methods for Chemical Analysis of High-Temperature, Electrical, Magnetic, and Other Similar Iron, Nickel, and Cobalt Alloys

    F75 Specification for Cobalt-28 Chromium-6 Molybdenum Alloy Castings and Casting Alloy for Surgical Implants (UNS R30075)

    F1537 Specification for Wrought Cobalt-28Chromium-6Molybdenum Alloys for Surgical Implants (UNS R31537, UNS R31538, and UNS R31539)

    ISO Standard

    ISO9001 Quality Management Standard


    ICS Code

    ICS Number Code 11.040.40 (Implants for surgery, prothetics and orthotics)

    UNSPSC Code

    UNSPSC Code 42320000(Orthopedic surgical implants)


    DOI: 10.1520/F1377

    ASTM International is a member of CrossRef.

    ASTM F1377

    Citing ASTM Standards
    Back to Top