This guide provides inspection techniques that may be used to examine electrical protective rubber products for irregularities. The methods have applications in manufacturing locations, testing facilities, and in the field where the products are used.

This guide also contains photographs that supplement the descriptions of terms listed in Section 3 and in Definitions F 819.

1. Scope

1.1 The purpose of this guide is to present methods and techniques for the visual inspection of electrical protective rubber products. This guide also includes descriptions and photographs of irregularities found in these products.

Note 1—It is not the purpose of this guide to establish the acceptance level of any irregularity described herein. That shall be established by the standard for each product.

1.2 The values stated in inch-pound units are to be regarded as standard. The SI units in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

Index Terms

electrical protective equipment-rubber; inflation inspection procedure; inspection; lighting inspection procedure; rolling inspection procedure; visual examination-electrical insulating materials; visual inspection of electrical protective rubber products guide;

ICS Code

ICS Number Code 29.035.20 (Plastic and rubber insulating materials)

Citing ASTM Standards

[Back to Top]