You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    ASTM F1225-99(2008)

    Standard Test Method for Measuring the Ribbon Exit Force for Film and Fabric Cartridges (Withdrawn 2015)

    Withdrawn Standard: ASTM F1225-99(2008) | Developed by Subcommittee: F05.02

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF 3 $45.60   ADD TO CART


    Withdrawn Rationale:

    This test method determines the exit force for typewriter and impact printer cartridges using film and fabric inked ribbons.

    Formerly under the jurisdiction of Committee F05 on Business Imaging Products, this test method was withdrawn in March 2015. This standard is being withdrawn without replacement due to its limited use by industry.

    1. Scope

    1.1 This test method determines the exit force for typewriter and impact printer cartridges using film and fabric inked ribbons.

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    F221 Terminology Relating to Carbon Paper and Inked Ribbon Products and Images Made Therefrom


    Referencing This Standard

    DOI: 10.1520/F1225-99R08

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM F1225-99(2008), Standard Test Method for Measuring the Ribbon Exit Force for Film and Fabric Cartridges (Withdrawn 2015), ASTM International, West Conshohocken, PA, 2008, www.astm.org

    Back to Top