ASTM F1197 - 00(2012)

    Standard Specification for Sliding Watertight Door Control Systems

    Active Standard ASTM F1197 | Developed by Subcommittee: F25.03

    Book of Standards Volume: 01.07


      Format Pages Price  
    PDF 5 $42.00   ADD TO CART
    Hardcopy (shipping and handling) 5 $42.00   ADD TO CART


    Abstract

    This specification covers the design, manufacture, and testing of controls and operating mechanisms for use with sliding watertight doors. Sliding watertight door control systems shall be classified as manual and power. Manual door control system requires the operator to apply a continuous cyclic force to the door controller to cause the operating mechanism to function. This type of control system has two kinds: mechanical system and hydraulic system. The power door control system requires only that the operator exert a minimal physical force to cause the operating mechanism to function. This type of control system has three kinds: electric system, hydraulic system, and electrohydraulic system. All sliding watertight doors shall be provided with a means of local and remote manual operation. Door control systems, both manual and power, shall be designed to open and close doors against a 15? list. In addition, the operating mechanisms shall be designed to close the door against a static head equivalent to a certain water height at least above the sill on the centerline of the door.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers the design, manufacture, and testing of controls and operating mechanisms for use with sliding watertight doors meeting the requirements of Specification F1196.

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are for information only.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    Institute of Electrical and Electronic Engineers Standards

    IEEE100 IEEE Standard Dictionary of Electrical and Electronic Terms

    Society of Automotive Engineers Standards

    J525 Welded and Cold Drawn Low Carbon Steel Tubing Annealed for Bending and Flaring

    ASTM Standards

    A312/A312M Specification for Seamless, Welded, and Heavily Cold Worked Austenitic Stainless Steel Pipes

    F1196 Specification for Sliding Watertight Door Assemblies

    Military Specification

    MIL-S-901 Shock Test, H.I. (High Impact); Shipboard Machinery, Equipment and Systems, Requirements for Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://www.dodssp.daps.mil.

    American Society of Mechanical Engineers

    SectionVIII,Division ASME Boiler and Pressure Vessel Code, Pressure Vessels Available from American Society of Mechanical Engineers (ASME), ASME International Headquarters, Three Park Ave., New York, NY 10016-5990, http://www.asme.org.

    National Electrical Manufacturers Association

    PublicationNumberIS1 Enclosures for Industrial Controls and Systems


    ICS Code

    ICS Number Code 47.020.10 (Hulls and their structure elements)

    UNSPSC Code

    UNSPSC Code 25111900(Marine craft systems and subassemblies)


    DOI: 10.1520/F1197-00R12

    ASTM International is a member of CrossRef.

    ASTM F1197

    Citing ASTM Standards
    Back to Top