ASTM F1176-01e1

    Standard Practice for Design and Installation of Underground Thermoplastic Irrigation Systems With Maximum Working Pressure of 125 psi (Withdrawn 2010)

    Withdrawn Standard: ASTM F1176-01e1 | Developed by Subcommittee: F17.61

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF Version 8 $50.40   ADD TO CART


    Withdrawn Rationale:

    This practice establishes procedures for the design and installation of thermoplastic flexible piping systems, for underground irrigation systems. Because there is considerable variability in end-use requirements, soil conditions, and thermoplastic piping characteristics, the intent of this practice is to outline general objectives and basics of systems design, proper installation procedures, and to provide pertinent references.

    Formerly under the jurisdiction of Committee F17 on Plastic Piping Systems, this practice was withdrawn in February 2010 in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

    1. Scope

    1.1 This practice establishes procedures for the design and installation of thermoplastic flexible piping systems, for underground irrigation systems. Because there is considerable variability in end-use requirements, soil conditions, and thermoplastic piping characteristics, the intent of this practice is to outline general objectives and basics of systems design, proper installation procedures, and to provide pertinent references.

    1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units which are for information only and are not considered standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1600 Terminology for Abbreviated Terms Relating to Plastics

    D2241 Specification for Poly(Vinyl Chloride) (PVC) Pressure-Rated Pipe (SDR Series)

    D2487 Practice for Classifications of Soils for Engineering Purposes (Unified Soil Classification System)

    D2488 Practice for Description and Identification of Soils (Visual-Manual Procedure)

    D2657 Practice for Heat-Joining Polyolefin Pipe and Fittings

    D2749 Symbols for Dimensions of Plastic Pipe Fittings

    F402 Practice for Safe Handling of Solvent Cements, Primers, and Cleaners Used for Joining Thermoplastic Pipe and Fittings

    F412 Terminology Relating to Plastic Piping Systems

    F690 Practice for Underground Installation of Thermoplastic Pressure Piping Irrigation Systems

    F714 Specification for Polyethylene (PE) Plastic Pipe (SDR-PR) Based on Outside Diameter

    F771 Specification for Polyethylene (PE) Thermoplastic High-Pressure Irrigation Pipeline Systems

    F1290 Practice for Electrofusion Joining Polyolefin Pipe and Fittings


    DOI: 10.1520/F1176-01E01

    ASTM International is a member of CrossRef.