ASTM F1135-99(2004)

    Standard Specification for Cadmium or Zinc Chromate Organic Corrosion Protective Coating for Fasteners (Withdrawn 2009)

    Withdrawn Standard: ASTM F1135-99(2004) | Developed by Subcommittee: F16.03

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF Version 2 $44.40   ADD TO CART


    Withdrawn Rationale:

    This specification covers the basic performance requirements for an electrolytic or mechanical coating of cadmium or zinc followed by a chromate and baked organic coating for ferrous and nonferrous fasteners.

    Formerly under the jurisdiction of Committee F16 on Fasteners, this specification was withdrawn in November 2009. This standard is being withdrawn with no replacement because there are no known users of this standard.

    1. Scope

    1.1 This specification covers the basic performance requirements for an electrolytic or mechanical coating of cadmium or zinc followed by a chromate and baked organic coating for ferrous and nonferrous fasteners.

    1.2 There are eight grades available under this standard; four for zinc and four for cadmium.

    1.3 This standard is intended primarily for fasteners such as nuts, bolts, and screws that require corrosion protection.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B117 Practice for Operating Salt Spray (Fog) Apparatus

    B244 Test Method for Measurement of Thickness of Anodic Coatings on Aluminum and of Other Nonconductive Coatings on Nonmagnetic Basis Metals with Eddy-Current Instruments

    B487 Test Method for Measurement of Metal and Oxide Coating Thickness by Microscopical Examination of a Cross Section

    B499 Test Method for Measurement of Coating Thickness by the Magnetic Method: Nonmagnetic Coatings on Magnetic Basis Metals

    B633 Specification for Electrodeposited Coatings of Zinc on Iron and Steel

    B695 Specification for Coatings of Zinc Mechanically Deposited on Iron and Steel

    B696 Specification for Coatings of Cadmium Mechanically Deposited

    D3359 Test Method for Measuring Adhesion by Tape Test

    F871M Specification for Electrodeposited Coatings on Threaded Components [Metric]

    F1470 Guide for Fastener Sampling for Specified Mechanical Properties and Performance Inspection

    F1940 Test Method for Process Control Verification to Prevent Hydrogen Embrittlement in Plated or Coated Fasteners


    DOI: 10.1520/F1135-99R04

    ASTM International is a member of CrossRef.