You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    ASTM F1033-00(2010)

    Standard Test Method for Comparing Lift-Off Correction Media (Withdrawn 2016)

    Withdrawn Standard: ASTM F1033-00(2010) | Developed by Subcommittee: F05.02

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF 3 $48.00   ADD TO CART


    Withdrawn Rationale:

    This test method provides information and test procedures for evaluating several performance qualities of typewriter or printer lift-off correction tapes and tabs on a comparative basis for general office use.

    Formerly under the jurisdiction of Committee F05 on Business Imaging Products, this test method was withdrawn in May 2016 in accordance with section 10.6.3 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

    1. Scope

    1.1 This test method provides information and test procedures for evaluating several performance qualities of typewriter or printer lift-off correction tapes and tabs on a comparative basis for general office use.

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D3460 Specification for White Watermarked and Unwatermarked Bond, Reprographic, and Laser Printer Cut-Sized Office Papers

    E97 Method of Test for Directional Reflectance Factor, 45-Deg 0-Deg, of Opaque Specimens by Broad-Band Filter Reflectometry


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F1033-00R10

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM F1033-00(2010), Standard Test Method for Comparing Lift-Off Correction Media (Withdrawn 2016), ASTM International, West Conshohocken, PA, 2010, www.astm.org

    Back to Top